Hi, I removed my xorg config but nothing change. I have tested the file in ~/.screenlayout dir: it is void. I edited it with xrandr instructions but don't work. From my previous message: I tested also Elive 2.9.97 on DVD and I have the same problem, this is for me, a signal that my config in xorg don't cause conflict because in Elive 2.9.96 this possibility is been removed. In fact tby Sy41CL - Installed Mode
Hi, My be that my xorg config cause conflict but that same problem is in the DVD of Elive 2.9.97. Also in it only very few configs and no possibility to add a new one. It is possible to known where the elive-multiscreens writes his configuration? My be I can resolve the problem editing this file. Thank you very much.by Sy41CL - Installed Mode
Hi, I tested also with reboot but nothing change! I think it is a problem of the software because with xrandr all works well, I desire only to automate the process. At this moment at every computer start, after login I have some seconds of monitor that turn black an normal then I can open terminology to send xrandr commands to the system. After this all works sufficiently normal. As soon as Iby Sy41CL - Installed Mode
Hi, I tested the new system for setting-up monitor resolution. I also upgraded my Elive 2.9.96 with apug and reinitialized the desktop but elive-multiscreens don't work in any way. It offers only very low resolutions and don't accept to create a new one. When I set the resolution via xrandr --newmode, --addmode and --output, the screen turns black and normal for many seconds. Even usby Sy41CL - Installed Mode
Thank you very much!!! I think will be a very good work for me that use an analogic monitor connected to VGA-0 and with non standard resolution of 2000x1380. As soon as 2.9.98 become available I install it to test. Again, Thank you so much!!!!by Sy41CL - Installed Mode
Hi, I installed Elive 2.9.96 Stable on my computer with monitor connected as VGA-0. I have always added the xrandr instructions to create, add and output my video resolution of 2000x1380_60.00 in the file /etc/X11/Xsession.d/50x11-common_determine-startup to automatize it and this worked fine, but totay this don't work in every way. Have you any help or suggestions for me? I thank you vby Sy41CL - Installed Mode